|
This bracket is mounted at
the bottom right corner of the radio/climate control bezel.
- Release the top right clip on the driver's kneepad and then remove
the bezel. Start at the top right corner and work your way around until
all the clips have been released.
- Lift the bezel out of the way. Disconnect all wires and plugs to get
more working space.
- Place the BR137 in the cavity at the bottom right and press it against
the rear wall. Use the bracket as a template to mark the four holes
to be drilled on the cavity.
- Drill the four holes and fasten the bracket. Suggestion: use #10 x
½" sheet metal screws and drill the pilot holes with a 5/64"
drill bit.
- Reattach all wires and plugs and replace the bezel and kneepad.
PLEASE NOTE: This bracket can be mounted closer to the driver by cutting
out the rear portion to fit and fastening it with only two screws.
|
